Labelmate.com
SET-UP
The ACH is supplied fully assembled, ready to use. A hexagonal wrench is also included.
• If your LABELMATE Label Rewinder or Label Unwinder has a standard Vanes-style Core Holder on it or a Quick-Chuck
Core Holder, loosen the set screw, remove the Core Holder and set it aside.
• Slide the Hub for the ACH over the motor Shaft of the Label Rewinder or Unwinder. Position the Hub so there is a gap
between the ACH Hub and the Rewinder or Unwinder Drive Unit Case.
• Using the supplied Hexagonal Wrench, tighten the set screw in the Hub onto the flat side of the motor Shaft until it is
snug. Your ACH is now ready for use.
USING THE ACH
• Loosen the three (A) Lock Levers on the back of the ACH Flange Plate (B)
• Grasp the front Flange Plate (C) with one hand and the rear Flange Plate (B) with the other.
• Rotate the Plates in opposite directions until the three Core Fingers (D) move to the center of the ACH next to
each other.
•
Slide an empty cardboard core only partway over the Fingers (D) leave (about 50mm/ 2’’) between the flange and the
core
• Now rotate the Flange plates in opposite directions to expand the Fingers against the inside of the cardboard core.
While you hold the Flanges so the Fingers are against the inside of the core, rotate one of the Locking Levers clockwise
until it is fixed. DO NOT OVER TIGHTEN.
• Move the other two (2) Locking Levers to the LOCK position. DO NOT OVER TIGHTEN.
• Now slide the core all the way on up against the inside Flange. If the core is too tight, loosen the Lock Levers and try
again sliding the core a little further over the Fingers to yield less tightness.
Refer to your Rewinder/Unwinder User Manual if needed for operation of the unit itself.
•
When rewinding is finished, place the Rewinder or Unwinder (DIRECTION) switch in the center, OFF, position.
• Slide the cardboard core and the label roll off the ACH.
Getting started
D
C
A
B
