INSTRUCTION MANUAL FOR THE INSTALLER
54
LSI 001 -EN- REV. 06
3. Press the button
again and the display will show the flashing symbols
4
3
2
1
.
4. Press the button
, the display will show:
Where
“1” identifies the dose selection (short coffee);
“00074” identifies the current number of pulses for the 1 short coffee dose;
identifies the
delivery group to be programmed.
5. Within 60 seconds fasten a filter holder (11 b) containing a dose of ground coffee to the group; put a
cup below the filter holder and press the button “1 short coffee” (25) on the corresponding touchpad.
6. When the coffee reaches the required dose, press the button “1 short coffee” (25) again to stop the
coffee delivery and confirm the required amount in the cup (the display will show the preset number of
pulses confirmed).
7. Repeat the same procedures for the other buttons (26-27-28) always on the touchpad on the right; to
pass from the first selection (1 short coffee) to the others, press the button
.
NOTE: Follow the same steps to program the remaining doses using the 1-cup filter (11b) or the
2-cup holder (11a) according to the dose to be programmed.
WARNING!
By programming the doses for the touchpad on the right, the other delivery groups automatically
acquire the same doses.
If you want to set a delivery group with different doses, you have to repeat the above mentioned procedure
on the touchpad you want to set, choosing the desired touchpad and moving with the buttons
and
(the symbol
indicates the group being set).
At the end of the
COFFEE DOSES setting phase, as soon as the last datum is confirmed with the button
, the display will show the flashing symbols
4
3
2
1
.
