INSTRUCTION MANUAL FOR THE INSTALLER
LSI 001 -EN- REV. 06
15
2.3
SELETRON MODEL
This appliance is equipped with an
electronic control board which controls
the water level in the boiler, the activation
of the motor pump and the cup warmer
heating element, the doses of each
delivery group (since the appliance has
a water dosing system based on flow
meters), and the heat regulation of the
boiler temperature, and it also shows any
possible malfunctions on the display.
GENERAL DESCRIpTION OF THE CONTROL pANEL
Control lights
Electric connection control light.
Control light indicating heat regulation status (whether the heating elements of the boiler are enabled).
Control light for the operating status of the boiler heating elements.
Control light for automatic boiler refill.
Control light for electric cup warmer heating elements.
Function of pushbuttons during standard operating phase (all DIpSWITCHES set to OFF)
Switching ON/OFF of boiler heating elements.
Switching ON/OFF of cup warmer heating elements.
Boiler temperature set reading.
• Pressing this button will show the set temperature of the boiler.
• Keeping this button pressed for about
5-6 seconds, automatically increases the set temperature by
2 °C and the message “Up” is shown, alternated with the temperature value. To cancel this status,
press the button again until the standard operating temperature is shown.
Coffee-counters display: pressing and holding down this button causes the indication “
d1” (dose 1) to
appear followed by the number corresponding to the total of all “doses 1” (short coffee) of all delivery groups;
releasing and pressing again, the indication “
d2” is displayed followed by the number corresponding to the
total of all “doses 2” (long coffee) of all delivery groups; same procedure to visualize the two remaining
doses, “
d3” (2 short coffees) and “d4” (2 long coffees).
View of the total number of all coffees delivered by the appliance (delivery operations carried out with the
free flow delivery button are not counted)
.
NOTE. The above buttons have a delayed operation (about 0.5 seconds) in order to prevent their
function from being activated by accident.
22
34
35
36
23
SET
SUPER 3000
SET
1
2
32
22
34
35
36
23
24 39
38
37
33
009
10
CONTROL PANEL
