INSTRUCTION MANUAL FOR THE INSTALLER
18
LSI 001 -EN- REV. 06
According to the touchpad that you are programming, the display (33) will show the code of the
delivery units that you are operating on:
1st group from the right
2nd group from the right
3rd group from the right
4th group from the right
NOTE
When you set a dose, you select a number of pulses on the flow meter so as to get the coffee amount
required. Each dose may be set from
50 to 1999 pulses.
However, since the display shows three digits only, when it exceeds 999 pulses, it starts again from 0,
while the decimal digits on the display are flashing (this means that you have exceeded 1000 pulses).
When you are using the display as a pulse counter, this is automatically reset to ‘0’ between one coffee
delivery operation and the next.
WARNING!
Should the power suddenly cut off while entering new data, check parameter values once power
is back again, because the data you have set might not have been saved properly (in this specific
event, the alarm A00 appears on the display. In this case repeat the data setting procedure).
We recommend that you do not select the self-diagnostic program at the same time as the data
setting program.
ELECTRIC CUp WARMER
Press the cup warmer function button
and check its operating status through the switching on of the
LED on the control-panel (23). To switch it off press the same button.
E2
E1
E3
E4
