Case Refrigeration Fan Motors and Lighting.
The case electrical wiring for the refrigeration fan motors and lighting are all terminated within
the electrical raceway as identified above. Connect the electrical wiring as follows:
Note:
It is recommended that the refrigeration fan motors and the lighting are
fused/CB independently at the AC service cabinet.
1. Read, understand, and follow all Warnings, Cautions, and Notes that pertain to the
installation of the electrical connections to the case.
2. Gain access to the electrical raceway following the procedures in the Disassembly chapter
of this manual for the kickplate removal.
3. Follow all NEC and local codes to provide AC to the case at the termination point located
on the left front of the case beneath the kickplate within the electrical raceway. Wire size is
dependant upon the type of case (load) and the distance of the case from the AC service.
Refer to the applicable case electrical table provided in Chapter 3 of this manual.
4. Connect the input AC to the case following all NEC and local codes.
5. Connect an isolated ground to the case ground provided. Case ground is identified by the
green wire.
6. Install the case kickplate using the instructions contained in the assembly chapter of this
manual.
WARNING! Ensure the Kickplate does not come in contact with the case
electrical wiring. Live electrical wiring that comes in contact with the case is a
shock hazard that may cause severe injury or death by electrocution.
Electric Defrost
When electric defrost has been ordered, the case has been pre-wired at the factory for this option.
Refrigeration Piping and Dehydration
WARNING! Seal around lines after connections are made. Keep direct flame
from bottom of case, as heat will disintegrate the bottom and insulation. Use a heat
shield when brazing near the bottom of the cases.
UNIT INSTALLATION
43
Summary of Contents for 6RLG3
