Preparation
Prepare the installation area as follows:
1. Clean area where case is to be installed.
2. Verify installation area is at least 15 feet from any outside entrances or heating and cooling
outlets.
3. Verify at least 2 feet distance between hot and cold cases.
4. Ensure floor loading will support the case and the case contents.
5. Ensure proper AC power is available. Refer to case AC input requirements located in the
electrical installation section of this
6. Ensure location will allow connection to drain lines and the drain line, when installed, will
meet the recommendations as set forth in the installation instructions for drain line
contained in the drain installation section of this
7. Ensure expansion valve in case is the proper valve for the type of refrigerant used at the
installation site.
Installation
Instructions
The following instructions are provided for properly installing the Kysor//Warren case. If there
are any questions during the installation process, please contact your Kysor//Warren Service
Representative.
Unpacking,
Moving, Loading, and Lifting
The following instructions are provided for unpacking, moving, loading, and lifting the case
prior to installation
Unpacking
The following instructions are provided for unpacking, moving, loading, and lifting the case
prior to installation.
1. Remove all shipping tape from lamps and ensure that all lamp ends are
snapped
in place.
Caution:
Use caution when removing the strapping in the following procedure as the
shelves are very heavy and could fall and cause damage to the case or case components.
2. Remove the strapping that secure the case shelves to the case and remove the shelves.
UNIT INSTALLATION
20
Summary of Contents for 6RLG3
