Interface Module Installation
17
3.1.4 Inserting a 1U Interface Module into Slot 1
3.2.1 Removing a 0.5U Interface Module
The steps for inserting a 1U interface module into Slot 1 is the same
as those for inserting a 0.5U interface module into an upper slot (Slot 2,
Slot 4, or Slot 6). For details, see section 3.1.2.
Figure 16 Removing Mounting Brackets
3.2 Dismounting
The steps for removing an interface module from an upper slot and a
lower slot are the same. Detailed steps are as follows:
Step 1:Remove the two screws securing the module to the switch.
Step 2:Pull out the mounting brackets.
Step 3:Remove the module from the switch by holding the brackets.
Step 4:Remove the brackets from the module, as shown in the following
figure.
1
Screw hole of the
interface module
Bracket of the
interface module
Summary of Contents for SICOM3000GPT
