Kverneland 4328LT, Service Manual

Page: 93 / 154

93
Assembling Swivel Gearbox
Assembling Swivel Gearbox
Assembling Swivel Gearbox
Assembling Swivel Gearbox
Assembling Swivel Gearbox
Assembling Swivel Gearbox
Assembling Swivel Gearbox
Assembling Swivel Gearbox
Tools : Pliers, press, pipe, hammer,
torque meter, snap ring pliers.
• Assemble parallel key (3) on
shaft (2).
• In order to assemble the gear on
shaft, to heat gear (35) or using
an adequate press.
• Assemble the gear (35), inner
ring (12) on shaft (2).
• Assemble pre-mounted shaft (2),
inside extension (30).
• Assemble inner ring (12a), using
a pipe and hammer.
Tools : Pipe, hammer, fork wrench
n°17, torque meter, chisel,
dynamometric wrench, snap ring
pliers, press.
•
Assemble shim (20),outer ring
(21) using a pipe and hammer,
inside cover (23).
• Assemble pre-mounted cover
(23), bolts (22) and tighten
manually.
• Hit the shaft (18) from both sides,
in order to set the axis. Check
the assembled axis preload,
using a torque meter, the value
must be to 0÷3 Kgcm
• If the value is not correct change
the shim set (20).
• Assemble outer ring (7) inside
housing (1), using a pipe and
hammer.
• Assemble snap ring (4), shim (5)
and inner ring (7) on shaft (18),
using a pipe and hammer.
• Assemble parallel key (3) on
shaft (18).
• In order to assemble the gear on
shaft, to heat gear (24) or using
an adequate press.
• Assemble gear (24), shim (33)
and inner ring (21), using a pipe
and hammer.
• Assemble the pre-mounted shaft
(18) inside housing (1).
• Disassemble cover (23), put a
Silicone film in the contact faces
between cover and housing.
• Assemble cover (23), bolts (22)
and tighten to 5÷6.4 kgm.
• Put an adhesive tape on splined
shaft (18) in order to prevent any
damage to oil seal lip (19).
• Assemble oil seal (19) and cap
(8), using pipe and hammer.
Maintenance