Kverneland 4328LT, Service Manual

Page: 60 / 154

60
Changing of lifting cylinder Changing of lifting cylinder Changing of lifting cylinder
• Tighten the springs in both side
of the machine to the required
setting.
• Tighten and secure the counter
nut as shown for; all models
except the 924-928.
Changing of lifting cylinder
Changing of lifting cylinder
Changing of lifting cylinder
• Tighten the springs in both side
of the machine to the required
setting.
• Tighten and secure the counter
nut as shown for the 924-928R
and T
• Attach the hydraulic system of
the machine to the tractor and
lower the cutting unit to top
position. • Lower the cutting unit down onto
the ground and continue activating
the hydraulic system of the tractor
in approx. 2-5 minutes.That
insures the machine's hydraulic
cylinders is filled with hydraulic oil.
• After that, carefully raise the
cutting unit and check that the
cutting unit is parallel to the main
frame of the machine.
• If not parallel- lower the cutting unit
down again and repeat the
procedure.
Changing of lifting cylinder
Changing of lifting cylinder
Hydraulic