Kverneland 4328LT, Service Manual

Page: 20 / 154

20
X
Bleeding of the clutch
• To be done when starting the
machine the first time or after a
prolonged period without use.
• Tighten all bolts on the friction
clutch.
• Fit and tighten the PTO shaft fully
on the drawbar.
• Loosen all the bolts on the
friction clutch.
• Block the cutter bar by placing a
wooden block between the two
cutting discs.
• Start the tractor and connect the
tractor's PTO outlet.
*Let the friction clutch rotate
freely for approx. 5 seconds at
the lowest possible speed, until it
is warm to the touch.
• Do not allow the friction clutch to
rotate for more than approx. 5
seconds at a time, as this may
damage the friction discs.
Friction clutch
X
Bleeding of the clutch
Bleeding of the clutch
Torque’s
Tighten the bolts
Loosen the bolts
Torque’s related to models
Block the cutter bar
Cutting with Torque
2 mtr. 40 (7’10 ½”) 1730 Nm.
2 mtr. 80 (10’6”) 1730 Nm.
3 mtr. 20 (11’10”) 1730 Nm.
3 mtr 50 (11’10”) 1730 Nm.
4 mtr. (13’1 ½ “) 1900 Nm.
Setting clutch of 4 mtr. is in position
IV, the rest in III (see also next page)