Kverneland 4328LT, Service Manual

Page: 113 / 154

113
Assembling Centre Gearbox
Assembling Centre Gearbox
Assembling Centre Gearbox
Assembling Centre Gearbox
Assembling Centre Gearbox
Assembling Centre Gearbox
Assembling Centre Gearbox
Assembling Centre Gearbox
• Clean all the components from
remaining grease and silicone.
• Replace any particular damaged.
• When assembling the taper roller
bearings pay attention to not
make any pressure on the cages
in order to avoid any damage.
• When assembling oil seals avoid
contact with cutting parts in order
to prevent any damage to the
inner lip.
• Assemble shim (5), outer ring (6)
inside cover (9), using pipe and
hammer.
• Assemble shims (3),(2), inner
ring (12), using pipe and hammer
on shaft (8).Assemble blank
washer (14), bolt (10) and tighten
to 5÷6.5 kgm.
• Assemble gear (4).
• Assemble shim (11) and inner
ring (6), using pipe and hammer.
Tools : Pipe, hammer, fork wrench
n°17,dynamometric wrench, torque
meter.
• Assemble outer rings (12) inside
housing (13) using pipe and
hammer.
• Assemble the pre-mounted shaft
(8).
• Assemble pre-mounted cover (9),
bolts (10) and lock manually.
• Hit the shaft (8) with a plastic
hammer in order to set the axis.
• Check the assembled axis
preload, using a torque meter,
the value must be to 0÷3 Kgcm
• If the value is not correct change
the shim set (5). (See figure 2.2.)
• Unscrew bolts (10) and
disassemble pre-mounted
cover (9).
Maintenance