Kurabo QuickGene-Auto240L, Operation Manual

Page: 53 / 78

3 Operation Procedures - Full Auto Protocols
39
QuickGene-Auto240L Operation Manual
3
■ Set the holders in the system
Holder Name Slot No.
Sample Tip Holder 1
Reagent Tip Holder 2
Cartridge/Waste Tube Holder 3A - C
Collection Tube Holder 4A - C
Lysate Tube 5
(1) Open the flap doors in the left/right side of the system
(2) Set the prepared holders in the corresponding slot with reference to the above chart.
To use the collection tube ID reading function, the collection tube holder should not be set in this
step, but instead set in accordance with the instructions of the operation panel in "3.8 Isolating
Operation"
Note:
・
The holder should be securely set in the slot until it contacts the stopper on the end.
・
Set a holder in the correct slot according to the manual and the identification label. If a
holder is forcibly set in a wrong slot, the holder or system may be damaged.
(3) Close the left/right flap doors.
1 2
3
A
5
Sample
Holder
Slot
Reagent
Container
Holder
Slot
4
A
3
B
4
B
3
C
4
C