PERIODIC SERVICE
64
B
Checking Intake Air Line
1. Check to see that hoses and hose clamps are tight and
not damaged.
2. If hoses and clamps are found worn or damaged,
replace or repair them at once.
B
Cleaning Engine Shroud
Consult your local KUBOTA Dealer for this service.
EVERY 400 HOURS
B
Changing Transmission Fluid and Rear
Axle Gear Case Oil (RH and LH)
To avoid personal injury:
A
Park the machine on a firm and level surface.
A
Be sure to stop the engine and remove the key
before changing or checking the oil.
A
Allow transmission case to cool down
sufficiently; oil can be hot and may cause
burns.
The fluid in the transmission case is also used for the
hydrostatic drive system.
1. To drain the transmission oil, place the oil pan
underneath the transmission case and remove the
drain plugs at the bottom of the transmission case.
2. After draining, open the air intake screen. Remove the
snap pin and push down the bottom clean lever to
open the dust cover; set the snap pin into the original
hole of the lever under the stay to keep the dust cover
open.
(1) Hose
(2) Clamp
(1) Drain plug of center case
Summary of Contents for ZG222A-AU
