Kubota ZG222A-AU, Operator'S Manual

Page: 65 / 105

PERIODIC SERVICE 48
B
Checking Gear Box Oil Level
To avoid personal injury:
A
Always stop the engine and remove the key
before checking oil.
1. Park the machine on a flat surface and lower the
mower to the ground.
To check the oil level, loosen the check plug and check
to see if the oil level is in the range of the check plug
port.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS AND FUEL" in "MAINTENANCE"
section.)
2. After checking, reinstall the check plug and oil inlet
plug securely.
1. Park the machine on a flat surface and lower the
mower to the ground.
To check the oil level, loosen the oil inlet plug with
gauge, wipe it clean, reinstall it and loosen it again.
Check to see if the oil level is between the notch and
tip.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS AND FUEL" in "MAINTENANCE"
section.)
2. After checking, reinstall the oil inlet plug with gauge
securely.
If serial numbers of mower are as indicated below
RCK48P-222Z:30000 and below
RCK54P-227Z:30000 and below
(1) Drain plug
(2) Check plug
(3) Oil inlet plug
(4) Gear case
(5) Check plug port (A) Oil level is acceptable within
this range.
(B) Oil level
If serial numbers of mower are as indicated below
RCK48P-222Z:30001 and above
RCK54P-227Z:30001 and above
(1) Drain plug
(2) Oil inlet plug with gauge
(3) Seal washer
(4) Gear case (A) Oil level is acceptable within
this range.
(B) Oil level