Kubota ZG222A-AU, Operator'S Manual

Page: 69 / 105

PERIODIC SERVICE 52
B
Cleaning Engine Shroud Panel
To avoid personal injury:
A
Make sure the engine is cool enough to touch
before removing shrouds and other
components.
A
Always shield eyes and a face from air deposits
and objects.
1. Stop the engine and apply the parking brake.
2. Open the hood.
3. Pull the latch lever on the seat panel rearward.
4. Raise the seat to the "LOCK" position.
5. Loosen four bolts and remove the muffler cover.
6. Loosen two screws (right & left) and remove the fan
cover.
7. Loosen four M6 bolts (right & left) and two M8 bolts
and remove the cover.
8. Remove large debris around the cooling fin and then
blow off small debris with a compressed air. Pressure
of compressed air must be under 205 kPa (2.1 kgf/
cm , 30 psi).
9. Blow off the debris inside the fan cover as shown in the
figure. Pressure of compressed air must be under 205
kPa (2.1 kgf/cm , 30 psi).
(1) Fan cover
(2) Screw
(1) Cover
(2) M6 bolt
(3) M8 bolt
(1) Cover
(2) M6 bolt
(1) Cooling fin
(1) Fan cover