Kubota ZG222A-AU, Operator'S Manual

Page: 76 / 105

59 PERIODIC SERVICE
B
Adjusting Throttle Cable
1. Move the throttle lever to the top position.
2. Make sure a part (2) is touching the restricting bolt (1).
3. If not, loosen the bolt (3) and pull the throttle lever
cable (4) in direction of the arrow (A) so that the part
(2) would touch the restricting bolt (1).
And then tighten the bolt (3).
EVERY 150 HOURS
B
Changing Gear Box Oil
To avoid personal injury:
A Be sure to stop the engine and remove the key
before changing the oil.
1. To drain the used oil, remove the drain plug and oil
inlet plug at the gear box and drain the oil completely
into the oil pan.
2. After draining reinstall the drain plug.
3. Remove the oil level check plug.
4. Fill with the new oil up to the check plug port.
(See "LUBRICANTS AND FUEL" in "MAINTENANCE"
section.)
5. After filling reinstall the check plug and oil inlet plug
securely.
(1) Throttle lever
(1) Restricting bolt
(2) Part
(3) Bolt
(4) Throttle lever cable (A) "PULL"
If serial numbers of mower are as indicated below
RCK48P-222Z:30000 and below
RCK54P-227Z:30000 and below
(1) Drain plug
(2) Check plug
(3) Oil inlet plug
(4) Gear case
(5) Check plug port (A) Oil level is acceptable within
this range.
(B) Oil level