Kubota G2160, Workshop Manual

Page: 364 / 395

QG-6
G2160-R48S, WSM G GENERAL
Checking Grass Hopper Net
CAUTION
• Be sure to stop engine before checking the grass hopper net
condition.
• The grass hopper net material is subject to deterioration and
wear. Check it frequently. Use only genuine replacement
net from KUBOTA.
• Make sure all shields and guards are securely in place
following all service, cleaning, or repair work.
1. The grass hopper net (1) is made of cloth and plastic.
2. Check grass hopper net (1) for deterioration, wear and damage.
3. After inspection, if the grass hopper net (1) is found worn or
deteriorated, replace it as shown below.
4. If the grass hopper net (1) is unusually dirty or grass stained, it
should be washed with a mild detergent and hung up to dry.
NOTE
■
• Do not attempt to dry the hopper net in clothes dryer!
W1020458
(2) Check Points of Initial 50 Hours
Replacing Transmission Oil Filter
CAUTION
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow transmission case to cool down sufficiently ; oil can
be hot and may cause burns.
1. The transmission oil filter cartridge (1) must be changed every
300 service hours.
2. Remove the transmission oil filter cartridge (1) with the filter
wrench.
3. Lightly tighten the screw (2) by using a screwdriver.
4. Apply a slight coat of oil onto the cartridge gasket.
5. To install the new cartridge, screw it in by hand.
Over tightening may cause deformation of rubber gasket.
6. After the new cartridge has been replaced, the transmission fluid
level normally lowers a little. Add fluid to proper level. Check for
oil leaks around filter gasket.
IMPORTANT
■
• To prevent serious damage to hydraulic system, the
replacement filter must be a highly efficient, 10
μ
m filter.
Use only a genuine KUBOTA filter or its equivalent.
W1013443
(1) Grass Hopper Net
(1) Transmission Oil Filter Cartridge (2) Screw
KiSC issued 11, 2006 A