Kubota G2160, Workshop Manual

Page: 308 / 395

PG-11
G2460G, WSM G GENERAL
[6] CHECK POINTS OF EVERY 1 YEAR
Flushing Cooling System and Changing Coolant
CAUTION
• Never open radiator cap when engine is hot.
• When opening, loosen cap slightly to the stop to relieve any
excess pressure before removing radiator cap completely.
1. Stop the engine and let cool down.
2. To drain the coolant, open the radiator drain plug (3) and engine
drain cock (4) and remove the radiator cap (1). The radiator cap
(1) must be removed to completely drain the coolant.
3. After all coolant is drained, fill with clean water and cooling
system cleaner.
4. Follow directions of the cleaner instruction.
5. After flushing, fill with clean water and anti-freeze until the coolant
level is just below the port.
6. Fill with clean water and anti-freeze upper level of the recovery
tank (2).
7. Start and operate the engine for few minutes.
8. Stop the engine. Check coolant level and add coolant if
necessary.
9. Install the radiator cap (1) securely.
W1037404
Replacing Fuel Line
1. Replace the fuel hoses (2) and hose clamps (1).
Refer to “Checking Fuel Line”. (See page PG-7.)
W1038054
(1) Radiator Cap
(2) Recovery Tank
(3) Radiator Drain Plug
(4) Engine Drain Cock A : Highest Level
B : Lowest Level
(1) Hose Clamp (2) Fuel Hose
KiSC issued 11, 2006 A