Kubota G2160, Workshop Manual

Page: 278 / 395

9-S5
G2160, WSM MOWER
Adjusting the Parallel Linkage
1. Park the machine on a level surface.
2. Make sure the mower blades are level in the way mentioned
below. Then tighten the lock nuts securely.
Adjust (L) of front rinks with lock nut so that (A) is 0
∼
5 mm (0
∼
0.2
in.). A=(Y)-(X)
CAUTION
• Shut off the engine and remove the key.
• Set parking brake.
• Allow the blades to stop before making adjustments.
• Blades may be sharp, when you handle blades, wear heavy
gloves or wrap end of blade with rag.
W1011500
Adjusting the Mower Deck (Side-to-Side)
1. Park the machine on a level surface.
2. Tire inflation pressure must be correct.
(See “TIRE” section.)
3. Raise the hydraulic lift lever to the top position. Turn the cutting
height control dial to adjust height to the desired height.
4. Lower the mower deck by pushing the hydraulic lift lever forward.
5. Turn the left blade so that it is parallel to rear axle.
Hold drive belt and turn the right blade so that it is parallel to axle.
6. Measure from each outside blade tip (L) to (R) to the level
surface. The difference between measurements should be less
than 1/8 in. (3 mm).
7. Remove the snap ring, plain washer and clevis pin. Adjust the lift
link length so that the difference between measurement (L) and
(R) is less than 1/8 in. (3 mm).
8. Reinstall the snap ring, plain washer and clevis pin.
CAUTION
• Shut off the engine and remove the key.
• Set parking brake.
• Allow the blades to stop before making adjustments.
• Blades may be sharp. When you handle blades, wear heavy
gloves or wrap end of blade with a rag.
W1011782
(1) Lift Link (Upper)
(2) Lift Link (Lower)
(3) Snap Ring (4) Plane Washer
(5) Clevis Pin
KiSC issued 11, 2006 A