KTS-Electronic GmbH & Co. KG
– GOLD SCAN II
7
2.1 Back side
1.
Charger
(connection to the charging device / separate plug): For charging the
battery the plug of the charging device has to be plugged into the provided
connector socket. The maximum charging time is 90 minutes (to avoid a defect
on the charger or the built-in battery, please do not exceed this time). The
connector of the charger should be removed after each charge.
2.
Headphone socket:
Any commercial headphones with 6.3 mm jack can be
plugged in. During use the loudspeaker is turned off. Matching, light weight
headphones are provided.
3.
Socket for coils:
The connecting socket for coils is located on the left side. The
connector plug of the searchcoil has to be plugged into the socket. Before
removing the plug the locking knob must be pressed, only then an extraction is
possible. The connector is compatible with all GOLD SCAN II searchcoils.
3. Search process
Please note the following:
Stay away from conducting overhead lines
Do not use cell phone during operation
Do not process any measurement during thunderstorms
Protect device from wetness
Accurate operation is only guaranteed with a fully charged battery
For operation or charging only use the components enclosed or released by KTS
GmbH & Co. KG.
GOLD SCAN II is a PC-connected metal detector, which is provided with the KTS-3D
software. First you should use this device like a common metal detector without 3D
software, i.e. search and identify your findings on your display (metal type), then
mark the place of discovery. Later you can scan the spot more precisely by using
your laptop with the KTS-3D software. The handling of laptops and the respective
settings will be explained in chapter 5 (page 15).
