KTM Freeride 250 R AUS 2014, Repair Manual

Page: 76 / 222

14 WHEELS
74
B01050-10
–
Position chain adjuster
3
. Mount nut
4
, but do not tighten it yet.
–
Make sure that chain adjusters
3
are fitted correctly on adjusting screws
5
.
–
Check the chain tension. ( p. 75)
–
Tighten nut
4
.
Guideline
Nut, rear wheel spindle M20x1.5 80 Nm (59 lbf ft)
Info
The wide adjustment range of the chain adjusters enables different sec-
ondary ratios with the same chain length.
Chain adjusters
3
can be turned by 180°.
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 10)
14.6.3 Removing the brake disc of the rear brake
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 10)
–
Remove the rear wheel. ( p. 72)
305972-10
Main work
–
Remove screws
1
. Remove the brake disc.
14.6.4 Installing the brake disc of the rear brake
305972-10
Main work
–
Clean the contact surface of the brake disc.
–
Position the brake disc with the label facing outward. Mount and tighten screws
1
.
Guideline
Screw, rear brake disc M6 14 Nm
(10.3 lbf ft) Loctite ® 243™
Finishing work
–
Install the rear wheel. ( p. 73)
–
Remove the motorcycle from the lift stand. ( p. 10)