16
ENGINE
118
300081-10
–
Remove shift forks
2
.
Info
Ensure that the pins remain in place.
300082-10
–
Remove the lock ring
4
and the stop disk.
300083-10
–
Pull both transmission shafts
5
out of the bearing seats together.
Info
The stop disk of the countershaft usually sticks to the bearing.
–
Take the O-ring off the countershaft
6
.
16.4
Work on individual parts
16.4.1
Work on the right section of the engine case
300094-10
–
Remove oil jet
1
.
–
Remove bearing locks of the main shaft bearing
3
, of the countershaft bearing
4
,
and of the shift drum bearing
5
.
–
Remove any sealing mass remnants and clean the engine case section thoroughly.
–
Pull the dowels out of the housing.
–
Warm the engine case section in an oven.
Guideline
150 °C (302 °F)
–
Knock the engine case section against a level wooden plate. This will cause the
bearings to drop out of the bearing seats.
Info
Any bearings that remain in the engine case section must be removed using
a suitable tool.
300095-10
–
Remove oil jet
2
.
–
Remove the cover plate
6
for the oil return line.
–
Press out the shaft seal ring
7
of the crankshaft from the inside to the outside.
–
Remove the shaft seal rings
8
of the water pump.
–
Press in the shaft seal ring
7
of the crankshaft from the outside to the inside with
the open side facing in.
Info
The shaft seal ring must be flush on the outside.
–
Press in the shaft seal rings of the water pump with the open side facing out so
that it is flush.
Summary of Contents for 2013 690 SMC R EU
Page 1: ...REPAIR MANUAL 2013 690 SMC R EU 690 SMC R AUS UK Art no 3206153en ...
Page 2: ......
Page 33: ...7 HANDLEBAR CONTROLS 31 Tighten counter nut 1 ...
Page 187: ...185 ...