KTM 2013 690 SMC R EU, Repair Manual

Page: 15 / 230

5 MOTORCYCLE
13
B00103-10
–
Turn the emergency OFF switch to the position .
–
Switch on the ignition by turning the ignition key to position ON .
After you switch on the ignition, you can hear the fuel pump working for about
two seconds. The function check of the combination instrument is run at the
same time.
–
Shift gear to neutral.
The green idling speed indicator lamp N lights up.
–
Press the electric starter button .
Info
Do not press the electric starter button until the combination instrument
function check is finished.
When starting,
DO NOT open the throttle. If you open the throttle during the
starting procedure, fuel is not injected by the engine management system
and the engine cannot start.
Press the starter for a maximum of 5 seconds. Wait for at least 5 seconds
before trying again.
This motorcycle is equipped with a safety starting system. You can only start
the engine if the transmission is in neutral or if the clutch lever is pulled
when a gear is engaged. If the side stand is folded out and you shift into
gear and release the clutch lever, the engine stops.
–
Take the weight off the side stand and swing it back up with your foot as far as it
will go.
5.10 Starting the motorcycle to make checks
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in an enclosed
space without an effective exhaust extraction system.
Info
Press the starter for a maximum of 5 seconds. Wait for a least 5 seconds before trying again.
B00103-10
–
Turn the emergency OFF switch to the position .
–
Shift gear to neutral.
–
Switch on the ignition.
–
Press the electric starter button .
Info
Do not open the throttle.