KTM 2013 690 SMC R EU, Repair Manual

Page: 124 / 230

16 ENGINE
122
16.4.4 Removing crankshaft bearing inner ring
302145-10
–
Fix the crankshaft with special tools
1
and
2
in the vise.
Upper part, pressing-out tool (75029047050) ( p. 216)
Under part, pressing-out tool (75029047051) ( p. 216)
302146-10
–
Heat the special tool
3
.
Guideline
150 °C (302 °F)
Tool for inner bearing race (58429037043) ( p. 211)
–
Push the heated special tool
3
on to the inner bearing race, press them hard
together, and pull them together off the crankshaft.
–
Take off the compensation shim.
–
Repeat the operation on the opposite side.
16.4.5 Removing balancer shaft drive wheel
Preparatory work
–
Remove the crankshaft bearing inner ring. ( p. 122)
302147-10
Main work
–
Screw in 2 M6 screws
1
in the threads. Tighten the two screws evenly to pull the
drive wheel
2
off the crankshaft.
16.4.6 Changing the connecting rod, conrod bearing, and crank pin
Preparatory work
–
Remove the crankshaft bearing inner ring. ( p. 122)
–
Remove the drive wheel of the balancer shaft. ( p. 122)
302151-10
Main work
–
Position the crankshaft with the special tool
1
in the press.
Under part, pressing-out tool (75029047051) ( p. 216)
–
Position the special tool
2
between the crankwebs.
Upper part, pressing-out tool (75029047050) ( p. 216)
–
Press the crank pin with the push-out drift of the special tool out of the upper
crankweb.
Pressing device for crankshaft, complete (75029047000) ( p. 216)
Info
Hold the lower crankweb.
–
Take off the connecting rod and bearing.