KTM 2013 690 SMC R EU, Repair Manual

Page: 152 / 230

16 ENGINE
150
16.5.12 Installing timing chain and timing chain sprocket
300150-10
–
Heat the timing chain sprocket and push it immediately on to the crankshaft.
Guideline
100 °C (212 °F)
–
Mount lock ring
1
.
300148-11
–
Thread the timing chain
2
in and lay it over the timing chain sprocket.
Info
If the timing chain is not new, pay attention to the direction of travel.
16.5.13 Installing timing chain rails
300046-11
–
Position the timing chain securing guide
1
.
Info
The cable of the crankshaft position sensor must be laid in the cable chan-
nel of the timing chain securing guide.
–
Thread in the timing chain tensioning rail
2
from above. Insert the support bush-
ing into the timing chain securing guide.
300045-11
–
Thread in the timing chain guide rail
3
from above. Insert the support bushing into
the timing chain securing guide.
–
Mount and tighten screws
4
.
Guideline
Screw, timing chain guide
rail M6 10 Nm
(7.4 lbf ft)
Loctite
®
243™
Screw, timing chain ten-
sioning rail M6 10 Nm
(7.4 lbf ft) Loctite ® 243™
Info
Ensure that there is no thread locking material at the collar of the screw;
otherwise, the timing chain tension rail could lock and break.
–
Check both timing chain rails for freedom of motion.
16.5.14 Installing rotor
300042-10
–
Ensure that the spring washer
1
is seated properly.
–
Degrease the cone of the crankshaft and the rotor.
–
Mount the rotor.
Info
Make sure that the crankshaft is not blocked.
–
Use the special tool to hold the rotor tight.
Holding spanner (75029091000) ( p. 218)