6
FORK, TRIPLE CLAMP
24
–
Push on lock ring
2
.
–
Grease and slide on seal ring
3
.
Lubricant (T511) (
p. 208)
Info
Sealing ring downward, open side upward.
–
Push on support ring
4
.
–
Remove the special tool.
200670-10
–
Sand the edges of the sliding bushings with 600-grain sandpaper, then clean and
grease them.
Fork oil (SAE 4) (48601166S1) (
p. 207)
200671-10
–
Push on the lower sliding bushing
5
.
–
Mount the upper sliding bushing
6
.
Info
Without using a tool, carefully pull the stack apart by hand.
200672-10
–
Heat up the outer tube in area
A
of the lower sliding bushings.
Guideline
50 °C (122 °F)
–
Slide the outer tube onto the inner tube.
–
Hold the lower sliding bushing with the longer side of the special tool.
Assembly tool (T1402S) (
p. 221)
–
Push the sliding bushing all the way into the outer tube.
200673-10
–
Position the support ring.
–
Hold the seal ring with the shorter side of the special tool.
Assembly tool (T1402S) (
p. 221)
–
Push the seal ring and support ring all the way into the outer tube.
200656-11
–
Mount lock ring
7
.
Info
The lock ring must engage audibly.
Summary of Contents for 2013 690 SMC R EU
Page 1: ...REPAIR MANUAL 2013 690 SMC R EU 690 SMC R AUS UK Art no 3206153en ...
Page 2: ......
Page 33: ...7 HANDLEBAR CONTROLS 31 Tighten counter nut 1 ...
Page 187: ...185 ...