ENGLISH
11
1
2
A
3
4
- Remove original screw
(1)
.
- Position the retaining plate for ON/OFF switch
(2)
and mount it with
screw M6x20
(1)
included in the scope of supply.
- Mount the ON/OFF switch on the retaining plate and plug the connector
of
Cable1
into the switch (Figure
A
).
NOTE:
After assembly, check all cables to ensure that the connectors are properly
positioned on the switch.
Requirement for ignition on:
When the switch is set to 1, the sensor box LED must be green.
If not, swap the connectors.
Connect the cable of the sensor box to the quick shifter.
Properly route all cables and secure them with cable ties.
Ensure that the cables are neither kinked nor pinched.
- Remove filter box cover
(4)
to gain access to the front stick coil.
- Make the plug-in connections as done previously for the stick coil.
- Connect
Cable2
to the quick shifter.
- Route
Cable2
forward.
- Pull off the original connector of the stick coil
(3)
behind the air filter
box.
- Plug the connector of
Cable2
into the stick coil and connect the original
connector with the other connector of
Cable2
.
- Route
Cable2
forward further.
