KSB Profibus PumpDrive 2, Supplementary Operating Manual

Page: 25 / 28

1 Supplementary Operating Manual
25 of 28
Profibus module
Table 18: PB/DIAGNOSIS_EXT_OPERATION (PhysicalBlock.DIAGNOSIS_EXT_OPERATION), input
Offset byte. Bit Data type Error code Parameter name Comments PumpDrive 2 message
0.0-3.0 BOOL 0x9701-0x9719 - Not supported -
3.1 BOOL 0x971A OverLoad Overload W58
3.2 BOOL 0x971B PartialLoad Part load W57
3.3-4.0 BOOL 0x971C-0x9721 - Not supported -
4.1 BOOL 0x9722 DriveOverheat Heat sink temperature high A7, W59
4.2 BOOL 0x9723 MotorOverheat Thermal motor protection A1
4.3 BOOL 0x9724 ContrOverheat PCB temperature high A8, W60
4.4 BOOL 0x9725 - Not supported -
4.5-4.6 BOOL 0x9700,
0x9726-0x977F - Reserved by PI, fixed at 0 -
4.7 BOOL 0x9780-0x978F Make-specific No master control A16
External message A30, W30
Resonance range W53
Actual value failure W55
Speed monitoring W63
Setpoint monitoring W64
Actual value monitoring W65
Flow rate monitoring W66
Suction pressure monitoring W67
Discharge pressure monitoring W68
Differential pressure monitoring W69
Temperature monitoring W70
Low flow velocity W80
Pipe flushing mode active I102
Pipe filling mode active I103
Overflow W83
Table 19: PB/DIAGNOSIS_EXT_AUX_DEVICE (PhysicalBlock.DIAGNOSIS_EXT_AUX_DEVICE), input
Offset byte. Bit Data type Error code Parameter name Comments PumpDrive 2 message
0.0 BOOL 0x9A01 AuxDeviceFault Not supported -
0.1 BOOL 0x9A02 SensorElement Broken wire W54
0.2-4.2 BOOL 0x9A03-0x9A23 - Not supported -
4.3 BOOL 0x9A24 - Not defined -
4.4-4.6 BOOL 0x9A00,
0x9A25-0x9A7F - Reserved by PI, fixed at 0 -
4.7 BOOL 0x9A80, 0x9A81 Make-specific PumpMeter communication W77