Malfunctions - Causes and Remedies
343
Malfunction
Possible cause
Remedy
The net tears off
directly after the
starting process or
during wrapping.
The blade bar has been fallen down
again immediately after the starting
process.
Remove impurities.
The roller brake is set too strong.
Check the setting of the brake device.
Blade bar is too low.
Check the setting of the blade bar.
Net is not transported
during the starting
process.
The dimensions of the net are
incorrect.
Just use net rollers with prescribed
dimensions.
Net rollers are not inserted correctly
in the reception device and / or the
roller brake device is not set
correctly.
Insert net roller according to the operating
instructions, set roller brake.
Net has not been inserted correctly in
the wrapping device.
Pull the net out of the wrapping device
and insert it again according to the
operating instructions.
The left-right display is
too sensitive.
In case of Comprima CF155:The
spring tubes on the belt tensioning
device are running too sluggishly
(see Chapter entitled “Setting the
Bale Diameter”)
Lubricate the inner tube.
Net is not cut off
neatly.
Blade bar does not fall completely
down.
Remove impurities.
Dull blades
Change blades
Ratchet mechanism does not come
up
Readjust cable
The net does not
reach the outside
edges of the bale.
Net is not decelerated correctly
during wrapping process.
Check the setting of the brake device.
Net has got caught on the cutting
blades.
Check setting of cutting blades.
Starter rollers of film wrapping device
are bent.
Check wrapping device and replace it, if
necessary.
Crop between spiral roller and
scraper
Readjust scraper.
Net spreader does not work.
Rotate the net spreader.
The scraper of cutting roller or
conveyor roller is blocked.
Change once again the side in the swath
before net is inserted.
Tailgate cannot be
opened correctly.
Hydraulic hose not plugged in.
Insert hydraulic hose into the appropriate
coupling.
The tailgate
cannot be
closed.
Sand, stones etc. have accumulated
on the collection plate.
Install the cover sheet of the collection
plate by one bore hole to the rear.
The bale does not roll
or rolls just slowly out
of the bale chamber.
The sides are filled too much or the
baling pressure is too high.
Do not drive sideways too far.
The floor conveyor
takes forage up at
front.
Material is too brittle (for example
straw)
a) Remove blade.
b) Reduce baling pressure.
Summary of Contents for Comprima CF 155 XC
Page 383: ......
