KROHNE TIDALFLUX IFM 4110 PF, Installation And Operating Instructions Manual

Page: 52 / 80

7.30830.32.00 52
LED 2
Red LED flashes Fatal error, hardware and/or
software fault Replace signal converter, see
sect. 8.3
LED 3
Cyclic flashing of red LED,
approx. 1 sec. Hardware fault Replace signal converter, see
sect. 8.3
LED 4
Red LED on continuously Hardware fault Replace signal converter, see
sect. 8.3
Group D Display Cause Remedial action
D1
LINE INT. Power failure
Note: no counting during power
failure Delete error message in
RESET/QUIT. menu, reset
totalizer if necessary.
D2
OVERFL. I Current output range exceeded Check instrument parameters
and correct if necessary. Reset
totalizer. Error message is
deleted automatically after
cause has been eliminated.
D3
OVERFL. P Pulse output range exceeded
Note:
totalizer deviation is possible Check instrument parameters
and correct if necessary. Reset
totalizer. Error message is
deleted automatically after
cause has been eliminated.
D4
ADW A/D converter range exceeded Error message is deleted
automatically after cause has
been eliminated.
D5
FATAL.ERROR Fatal error, all outputs are set to
“min” values Replace signal converter, see
sect. 8.3 or consult Krohne
Service, having first noted down
hardware information and error
status, see sect. 7.3, Fct. 2.02.
D6
TOTALIZER Counts lost
(overflow, data error) Delete error message in
RESET/QUIT. menu.
D7
I SHORT Short circuit at current output Check electrical connection acc.
to Sect. 2.2 and correct if
necessary. Load
≥
15
Ω
!
D8
I OPEN Open current output
Provide load
≤
500
Ω
!
D9
ADC PARAM.
D10
ADC HARDW.
D11
ADC GAIN
Fault detected on the ADC
printed circuit Check measuring accuracy.
Replace ADC printed circuit
board (see Sect. 8.4) or consult
Krohne Service, having first
noted down hardware
information and error status, see
Sect. 7.3, Fct. 2.02
D12
STARTUP, cyclic flashing Hardware fault Replace signal converter or
consult Krohne Service, having
first noted down hardware
information and error status, see
sect. 7.3, Fct. 2.02
D13
BUSY Displays for flow, totalizers and
messages disabled Change setting in Fct. 1.4
D14
unsteady display Low electrical conductivity,
high solids content, pulsating flow Increase time constant in Fct.
1.2.
Power supply OFF Switch on power supply.
D15
No display
Check power supply fuse F7 (F1
and possibly F2 for DC versions)
in terminal compartment Replace if blown, see sect. 8.1.