7.30830.32.00
75
À
À
ADC printed circuit board, analog/digital converter
(terminals 1, 2, 3, 20 and 30)
•
Signal processor protected against overload, for quick and precise processing of flow peaks up to and exceeding
20 m/s or 60 ft/s.
•
Digital signal processor, sequential control and test routines.
•
Patented high-resolution analog/digital converter, digitally controlled and monitored.
•
Input amplifier allowing control of potential of signal line shielding (bootstrap).
•
User parameter and internal calibration values are stored in separate EEPROMs (easily replaceable)
Á
Á
FSV printed circuit board, field current supply
(terminals 7 and 8)
•
Large signal-to-noise ratio owing to low-loss field current supply with high frequencies and high currents.
•
Pulsed direct current which is precisely controlled electronically, for the magnetic coils of the primary head.
•
Operating and calibrating data are stored in an EEPROM so the PCB can be easily replaced without the need for
re-calibration.
Â
Â
BDE printed circuit board, motherboard
•
Large illuminated LC display.
•
15 keys for operator control of signal converter.
•
Can be retrofitted with optional operator control by bar magnet.
•
Distribution of general signals such as ImoCom bus, power supply.
Ã
Ã
I/O printed circuit board, inputs and outputs
•
Groups, input and outputs are galvanically isolated from each other and from all other circuits.
•
Power supply source for the inactive inputs and outputs.
•
Specific supply source for the inactive inputs and outputs.
•
Specific Krohne circuit KSA 04 for fine quantization of output pulses across a wide dynamic range.
•
Active current output
I
(e.g. 0/4 – 20 mA) with load control
•
Pulse output
P
for electronic totalizers, max. 10 Hz.
•
Pulse output
A1
for electromechanical totalizers, max. 50 Hz, can also be used as status output
A1
.
•
Several status outputs
A1, A2, D1, D2.
•
Control inputs
C1
and
C2
.
Ä
Ä
ImoCom bus plug
Connecting external operating and testing devices, e.g. RS232 adapter and CONFIG software for operator control of
signal converter by MS-DOS PC or laptop.
Å
Å
Slots for plug-in modules, for upgrading or converting the signal converter
