Kramer Electronics Ltd.
VS-3232DN-EM
– Using the Input / Output Cards
45
The
DTAxr-OUT4-F32
outputs four HDBaseT signals from the chassis with optional de-
embedding/embedding of unbalanced stereo audio to/from each HDBT port on the card:
The
DTAxr-IN4-F32
and
DTAxr-OUT4-F32
cards include a terminal block for connecting
analog audio, RS-232, an IR emitter, such as the
C-A35M/IRE
, or an IR receiver, such as the
C-A35M/IRRN
. For information on the IR wiring scheme, see
. For information on connecting via RS-232, see
When a multi-channel audio input signal is routed to a card with stereo analog audio outputs,
the analog audio out connectors output the front right and front left audio channels only.
Each audio jack enables audio insertion/extraction only to/from its corresponding HDMI port.
DTAxr-IN4-F32 / DTAxr-OUT4-F32 Configuration
The
DTAxr-IN4-F32
configuration table appears as follows:
DTAxr-IN4-F32 Input Card
Parameter
Description
Default
Audio
Select
AUD-Embedded
—HDMI audio is selected.
AUD-Analog
—Analog audio from the 16-pin terminal block is selected.
Note
: Not applicable when the audio port is set to output (ST=1).
AUD-
Embedded
ST
Sets the direction of the audio port:
0
—Audio is set to input
1
—Audio is set to output
Note
: The direction of the audio signal for each port is indicated by the I/O
LED above the terminal blocks:
ON
—Audio is set to input
OFF
—Audio is set to output
0
HDCP
Turn HDCP on and off.
*1=EN, 0=DIS.
1
XTRA
Enables range extender. Off for distances of up to 100m at 4K@60Hz 4:2:0
or 4K@30Hz 4:4:4 or up to 130m at 2K; On for distances of up to 180m at
1080p @60Hz @24bpp.
*0:ON, 1:OFF.
Note
: Distances are valid when using Kramer BC-UNIKAT cables.
1
Reset Input
Re-power: power cycle the port.
Factory Default: perform a factory reset of the port to default values.
Re-power
Volume
Sets the audio output volume (0
–70).
Note
: Not applicable when digital audio is selected.
50
Audio
Balance
Sets the audio output channel balance (0
–100).
Note
: Not applicable when digital audio is selected.
50
Audio Bass
Sets the audio output bass level (0
–15).
Note
: Not applicable when digital audio is selected.
7
Audio
Treble
Sets the audio output treble level (0
–15).
Note
: Not applicable when digital audio is selected.
7
Audio Mute
MUTE
—Mutes the audio input. Audio is unmuted if any of the audio
parameters are modified.
Non-MUTE
—Unmutes the audio input.
Note
: Not applicable when digital audio is selected.
Non-MUTE