Kramer Electronics Ltd.
VS-3232DN-EM
– Operating Your Video Matrix Switcher
22
▪
In the At Once mode, the switching takes place immediately and the LCD display
shows a segment of the input-output status that includes the switched input and
output (for example, 14-12).
In the Confirm mode, the LCD display shows the following:
In 14 => Out 12
Incomplete actions time out after approximately 15 seconds.
▪
In the Confirm mode, press the flashing TAKE button to switch the input to the
output.
Switching Several Inputs to Several Outputs
If you want to switch several inputs to several outputs you must be in the Confirm mode.
In the Confirm mode you can enter a batch of several actions and then confirm the batch by
pressing TAKE once (simultaneously switching several output-input combinations).
To switch several inputs to several outputs in the Confirm mode:
1. Using the numeric keypad, enter an output-input combination.
The TAKE button flashes.
2. Enter additional output-input combinations.
The LCD display can show up to five pending actions (although the batch is not limited
to five actions), as follows:
09 => 06 05 => 07
In this example, input 9 is set to switch to output 6 and input 5 is set to switch to output
7.
3. After entering all output/input combinations, press the flashing TAKE button to confirm
the actions.
The inputs switch to the respective outputs as shown on the LCD display and the TAKE
LED is lit.
Turning an Output Off
Turning an output off means that there is no input switched to this output. This is indicated on
the display by the Input being blank underneath the relevant Output.
To turn an output off:
1. Press MENU.
The Menu buttons light and are enabled.
2. Press OFF (3) on the numeric keypad (see
).
The following message is displayed:
out__ => OFF
3. Use the numeric keypad to turn the required output off.
The output is turned off.
To turn an output off in the Confirm mode:
•
Repeat the steps above and then press the flashing TAKE button to confirm the action.
