Kramer VS-3232DN-EM, User Manual

Page: 11 / 128

Kramer Electronics Ltd.
VS-3232DN-EM
– Introduction
8
9 BREAKAWAY Button Press to exit a menu (see Using the Configuration
Menus on page 24 ).
10 DEFAULT SETUP Button Press to recall the default setup (see Recalling the Default
Setup on page 23 ).
11 OUTPUTS/INPUTS
LCD Display
Displays the outputs (upper row) switched to the selected
inputs (lower row), (see
Startup Display on page 19 ).
Displays user interface messages and menus.
12 IR Receiver Infrared remote control sensor (for future use).
13 IR LED Lights yellow when receiving commands from the IR
remote control transmitter (for future use).
14 TAKE Button Press to confirm actions (see Confirming a Switching
Action on page 21 ).
15 MENU Button Press once to enable the ALL, OFF, STO and RCL buttons
(see
Using the Configuration Menus on page 24 ).
Press again to enter the configuration menu (see Using
the Config Menu on page 28 ).
When in a Menu, press to cycle through the menu items.
16 LOCK Button Press and hold for approximately 2 sec to lock/unlock the
front panel buttons (see
Locking the Front Panel
Buttons on page 23 ).
17 Power Supply Supplies power to the device.
18
19 POWER LED Lights green when power supply is active and the device is
powered on.
20 ERROR LED Lights red when an error is detected. Briefly lights red
immediately following a power disruption (e.g., cable
disconnection, power off, and so on).
Figure 2: VS-3232DN-EM Front Panel Numeric Keypad
# Feature Function
21
◄ (Backward)
Press to shift the display right (the LCD display only shows 13 cross-points
out of a total of 32).
22 1, 2, 3, 4, 5, 6, 7, 8,
9, 0
Numeric keypad, 1 to 0.
23
► (Forward)
Press to shift the display left (the LCD display only shows 13 cross-points out
of a total of 32).