Kramer TP-594Rxr, User Manual

Page: 8 / 67

Kramer Electronics Ltd.
TP-594Txr, TP-594Rxr
– Defining the Transmitter and Receiver
6
Defining TP-594Rxr
Figure 2: TP-594Rxr HDMI Line Receiver
# Feature Function
GATEWAY Tx LED Lights blue to indicate gateway activity of any RS-232, IR or CEC signals
sent, as selected in the embedded web pages.
GATEWAY Rx LED Lights blue to indicate gateway activity of any RS-232, IR or CEC signals
received, as selected in the embedded web pages.
POE STATUS LED Lights green when power is received over the TP connection.
LINK LED Lights green when the HDBT link is valid.
ON LED Lights green when the device receives power.
HDMI OUT Connector Connect to an HDMI acceptor.
IR 3.5mm Mini Jack
Connector Use for one of the following functions:
•
Connect to an IR emitter cable to control a local device from the
transmitter ( TP-594Txr ) side.
•
Connect to an IR sensor cable to control a remote device connected
to the TP-594Txr transmitter.
•
Connect to an IR emitter cable to control an IR-enabled device via
the Ethernet (see Defining TP-594Rxr Gateway and Ports Activation
on page 38 ).
RS-232 3-pin Terminal
Block Connector Connect to an RS-232 device to control a remote device that is connected
to
TP-594Txr or connect to a device that is controlled via the Ethernet
(see Defining TP-594Rxr Gateway and Ports Activation on page 38 ).
AUDIO 5-pin Terminal
Block Connector Connect to a stereo balanced audio source or an acceptor (the connection
type is defined via the embedded web pages):
•
Connect an audio acceptor to output the audio signal received from
the audio source on the transmitter side via the HDBT link.
•
Connect an audio source to extend an audio signal to the audio
acceptor on the TP-594Txr via the HDBT link.
TOSLINK IN Connector Digital audio on a TOSLINK optical female connector for digital audio input
that is extended to the transmitter.
HDBT IN Connector Connect to the RJ-45 HDBT OUT connector on a transmitter (for example,
TP-594Txr or TP-590Txr ) to extend the signals between TP-594Rxr and
the transmitter.
SETUP 4-way
DIP-switches Set the operation DIP-switches (see Setting the DIP-Switches
on page 22 ).
CONTROL RS-232 3-pin
Terminal Block
Connector Connect to a PC to control the device.
CONTROL ETHERNET
RJ-45 Connector Connect to a PC to control the device or for LAN extension.
RESET Recessed Button Press and hold to reset settings to factory default values.
PROG USB Port Connect to a USB memory device to upgrade the firmware.
12V DC Power
Connector 12V DC connector for powering the unit when unit is not powered via the
HDBT link by the transmitter.
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
DRAFT