Kramer TP-594Rxr, User Manual

Page: 25 / 67

Kramer Electronics Ltd.
TP-594Txr, TP-594Rxr
– Operating and Controlling
TP-594Txr and TP-594Rxr
23
Operating via Ethernet
You can connect to the TP-594Txr via Ethernet using either of the following methods:
•
Directly to the PC using a crossover cable (see Connecting the Ethernet Port Directly to
a PC on page 23 ).
•
Via a network hub, switch, or router, using a straight-through cable (see Connecting the
Ethernet Port via a Network Hub or Switch on page 24 ).
Note : If you want to connect via a router and your IT system is based on IPv6, speak to your
IT department for specific installation instructions.
Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the TP-594Txr directly to the Ethernet port on your PC
using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the TP-594Txr
with the factory configured default IP address
After connecting the TP-594Txr to the Ethernet port, configure your PC as follows:
1. Click Start > Control Panel > Network and Sharing Center .
2. Click Change Adapter Settings .
3. Highlight the network adapter you want to use to connect to the device and click Change
settings of this connection .
The Local Area Connection Properties window for the selected network adapter
appears.
Figure 24: Local Area Connection Properties Window
4. Highlight Internet Protocol Version 4 (TCP/IPv4) .
DRAFT