Kramer Electronics Ltd.
TP-594Txr, TP-594Rxr
– Routing Audio Signals
15
5. Under Audio Settings:
▪
Set Audio De-embedding Source to
Line-HDMI IN
.
▪
Set Audio De-embedding Destination to
Analog OUT
.
When Audio De-embedding Destination is set to None, the AUDIO analog port
is muted.
Figure 13: TP-594Rxr Video and Audio Page
– Auto Priority Audio Settings
If ARC Output Source is set to
Analog IN
, the above settings are automatically set to
None
and analog output is disabled.
The
TP-594Txr
priority audio source is routed to the
TP-594Rxr
HDMI and analog audio
outputs.
Routing an Analog Audio Source to the Receiver for Auto-play
when No Video Signal is Present
To route the analog audio source to the receiver without video signal display:
1. Connect an audio source to the AUDIO 5-pin terminal block connector.
2. Mute or disconnect the HDMI source connected to the HDMI connector.
3. In the
TP-594Txr
Navigation pane, click
Video & Audio
. The Video and Audio settings
page appears.
4. Under Video Settings:
▪
Set Analog Audio Auto-play Upon No Video Signal to
On
.
Figure 14: TP-594Rxr Video and Audio Page
– Audio Auto-play Set to On
5. Under Audio Settings:
▪
Set Audio De-embedding Source to
Manual
.
▪
Set Audio De-embedding Destination to
Analog
.
▪
View the active audio Current Selection (
Analog
in this example).
When the Audio Embedding Selection Priority on the
TP-594Txr
is set to
Analog
, ARC cannot be output via the analog AUDIO port.
Figure 15: TP-594Txr Video and Audio Page
– Analog Audio to Receiver Settings (no HDMI signal)
DRAFT
