30
Error messages
When you turn on the power, the WAVEDRUM will auto-
matically perform an internal check. If a problem is
found, one of the following error messages is shown.
Take the appropriate action listed here.
E. 00
: The pressure sensor value is invalid. Calibrate the
pressure sensor so that
U a L
(Value) is 0.
E. 01
: The user data has been lost. Initialize the data as
described in “Restoring the factory settings.”
E.10
: The pressure sensor has malfunctioned. Make sure
that your hand or another object is not resting on the
head. If any object is resting on the head, remove it, and
then turn the power off and on again. If the same indica-
tion still appears, press any one of the buttons to start up
the WAVEDRUM, and then calibrate the pressure so that
U a L
(Value) is 0. If you are unable to adjust the value to
0, please contact your nearby Korg dealer.
E. 11
: A system error has occurred. Stop using the WAVE-
DRUM, and contact your nearby Korg dealer.
Troubleshooting
Sound is different than another WAVEDRUM
As is the case for many other instruments, each individ-
ual WAVEDRUM will differ slightly depending on how it
is tuned, the conditions how it is played, and how it has
been maintained.
This means that even if the same heads are installed on
several WAVEDRUMs and the same program settings are
used, they may not necessarily produce identical sounds
when played.
In other words, the WAVEDRUM is an electronic musical
instrument that also has some characteristics of an acous-
tic instrument.
The sound of another instrument causes the WAVE-
DRUM to resonate and be triggered unintentionally
You may be able to prevent this by calibrating the head.
Feedback occurs
Consider using an equalizer or limiter of your PA sys-
tem to prevent feedback and protect the amp and speaker
system.
You may be able to prevent this by calibrating the head.
Does not respond to pressure applied to the head
Could the drum head be stretched too tightly? If the head
is too tight, the pressure sensor will not work correctly.
You may be able to fix this by tuning the head appropri-
ately.
Performing the pressure calibration may make the sen-
sor respond correctly.
No sound from the device connected to the AUX IN jack
Have you appropriately raised the AUX IN jack’s mix
level in Global mode?
Is the volume of the connected device turned up?
Are the connections correct? Is the power turned on?
Specifications
Dynamic Percussion Synthesizer
Algorithms:
Single-size 26, Double-size 10
PCM instruments:
Head 100, Rim 100
Programs:
200 (User 100, Preset 100)
Loop phrase:
100
Effect:
Reverb, Delay
Controls:
VOLUME knob, WRITE button, Buttons 1 -
4, BANK/MODE button, VALUE knob
Input/Output jacks:
Output L, R (Monaural phone jack),
Phones (Stereo mini phone jack), AUX IN (Stereo mini
phone jack)
Display:
3-character 7-segment LED
Sampling frequency:
48 kHz
A/D, D/A conversion:
24 bit
Power supply:
DC9V 1.7A
Dimensions (WxDxH):
344×349×75 mm /
13.54"x13.74"x2.95"
Weight:
2.0 kg / 4.41 lbs.
Included items:
AC Adapter, Tuning key, Allen wrench
Options:
Replacement Head HD-WD, Percussion Stand
ST-WD
* Specifications and appearance are subject to change
without notice for improvement.
Summary of Contents for Wavedrum
Page 1: ...1 Owner s Manual E 2 ...
