JetNet 4706/4706f Industrial Managed PoE Switch
41
Ingress Filtering : Disabled
Acceptable Frame Type : All
Port Security : Disabled
Auto Negotiation : Disable
Loopback Mode : None
STP Status: forwarding
Default CoS Value for untagged packets is 0.
Mdix mode is Disable.
Medium mode is Copper.
Note: Administrative Status -> Port state of the port. Operating
status -> Current status of the port. Duplex -> Duplex mode of
the port. Speed -> Speed mode of the port. Flow control ->
Flow Control status of the port.
Rate Control
Rate Control –
Ingress or Egress
Switch(config-if)# rate-limit
egress Outgoing packets
ingress Incoming packets
Note: To enable rate control, you should select the Ingress or
Egress rule first; then assign the packet type and bandwidth.
Rate Control – Filter
Packet Type
Switch(config-if)# rate-limit ingress mode
all Limit all frames
broadcast Limit Broadcast frames
flooded-unicast Limit Broadcast, Multicast and flooded unicast frames
multicast Limit Broadcast and Multicast frames
Switch(config-if)# rate-limit ingress mode broadcast
Set the ingress limit mode broadcast ok.
Rate Control -
Bandwidth
Switch(config-if)# rate-limit ingress bandwidth
0 0 is no limit
1024 1024 is 1024Kbps
128 128 is 128Kbps
2048 2048 is 2048Kbps
256 256 is 256Kbps
4096 4096 is 4096Kbps
512 512 is 512Kbps
8192 8192 is 8192Kbps
Switch(config-if)# rate-limit ingress bandwidth 8192
Set the ingress rate limit to 8192k for Port 1.
4.4 Power over Ethernet
Power over Ethernet is one of the key features of
JetNet 4706/4706f
. It is in compliances with
IEEE 802.3af standards and supports High power forwarding capability.
JetNet 4706/4706f
adopts 4-Port PoE injectors in port 1 to port 4, each port with the ability to deliver a 0.615mA
current.
The following commands are included in this section:
4.4.1 PoE Control
4.4.2 PoE Scheduling
4.4.3 PoE Status
