58
Note: Administrative Status -> Port state of the port. Operating
status -> Current status of the port. Duplex -> Duplex mode of
the port. Speed -> Speed mode of the port. Flow control ->
Flow Control status of the port.
Rate Control
Rate Control –
Ingress or Egress
Switch(config-if)# rate-limit
egress Outgoing packets
ingress Incoming packets
Note: To enable rate control, you should select the Ingress or
Egress rule first; then assign the packet type and bandwidth.
Rate Control – Filter
Packet Type
Switch(config-if)# rate-limit ingress mode
all Limit all frames
broadcast Limit Broadcast frames
flooded-unicast Limit Broadcast, Multicast and flooded unicast frames
multicast Limit Broadcast and Multicast frames
Switch(config-if)# rate-limit ingress mode broadcast
Set the ingress limit mode broadcast ok.
Rate Control -
Bandwidth
Switch(config-if)# rate-limit ingress bandwidth
<0-100> Limit in magabits per second (0 is no limit)
Switch(config-if)# rate-limit ingress bandwidth 8
Set the ingress rate limit 8Mbps for Port 1.
Port Trunking
LACP
Switch(config)# lacp group 1 fa6-8
Group 1 based on LACP(802.3ad) is enabled!
Note: The interface list is fa1-8
Note: different speed port can’t be aggregated together.
Static Trunk
Switch(config)# trunk group 2 fa4-5
Trunk group 2 enable ok!
Display - LACP
Swhitch# show lacp internal
LACP group 1 internal information:
LACP Port Admin Oper Port
Port Priority Key Key State
----- ----------- -------- -------- -------
6 1 6 6 0x45
7 1 7 7 0x45
8 1 8 8 0x45
LACP group 2 is inactive
LACP group 3 is inactive
LACP group 4 is inactive
Display - Trunk
Switch# show trunk group 1
FLAGS: I -> Individual P -> In channel
D -> Port Down
Trunk Group
GroupID Protocol Ports
--------+---------+------------------------------------
1 LACP 6(D) 7(D) 8(D)
Switch# show trunk group 2
FLAGS: I -> Individual P -> In channel
D -> Port Down
