16
2.9 DIN-Rail Mounting Installation
The DIN-Rail clip is already screwed tighten on the rear side of JetNet
JetNet 4508V2/ JetNet 4508f V2 when shipping. If the DIN-Rail clip is not
screwed on the JetNet 4508 V2/ JetNet 4508f V2, please contact your
distributor to get the DIN rail clip set. The DIN rail clip supports EN50022
standard. In the diagram following includes the dimension of EN50022 DIN
rail for your refer.
Follow the steps below to mount JetNet Managed Switch to the DIN-Rail
track:
1.
First, insert the DIN-Rail track upper side into the upper end of
DIN-Rail clip.
2. Lightly push the bottom of DIN-Rail clip into the track.
3. Check if DIN-Rail clip is tightly attached on the track.
4. To remove JetNet 4508V2/ JetNet 4508f V2 from the track, reverse
the steps above.
Notes: The DIN Rail should compliance with DIN EN50022 standard. Using wrong
DIN rail may cause system install unsafe.
