Kontron NSC2U, Product Manual

Page: 92 / 152

NSC2U Server—Optional Component Installations
Kontron IP Network Server NSC2U
Product Guide, rev. 1.4 December 2009
92
5. Attach the eUSB SSD to the interposer card as shown (“D”).
6. Insert and tighten the screw that will hold the VSSD in place on the interposer card
as shown (“E”).
7. If this is the last task you are performing, replace the processor air duct and the
top cover of the chassis. Reconnect all the external devices and plug in the power
cord(s).
For information about mounting the server in a rack, see Section 3.5, “Installing
the Server into a Rack” on page 48
4.8 Installing Hardware RAID 5 Components
The RAID5 Kit includes the following three components for hardware RAID support:
• Hardware RAID activation key
• RAID DIMM
• RAID Intelligent Battery Backup Unit (IBBU)
The optional hardware RAID 5 components are installed on the SAS front panel (SFP)
board in the front right side of the chassis. Before installing the RAID components, you
must first remove the chassis top cover and the processor air duct. For instructions, see
Section 3.2.1 and Section 3.2.5 . To install the IBBU, you must also remove the front
panel bezel. For instructions, see Section 3.2.3 .
Figure 77. Installing the Value Solid State Drive
D
E
TS000503