NSC2U Server—Server Component Installations and Upgrades
Kontron IP Network Server NSC2U
Product Guide, rev. 1.4
December 2009
42
3. Open both DIMM socket levers. (“A”)
4. Note the location of the alignment notch. (“B”)
5. Insert the DIMM making sure the connector edge of the DIMM aligns correctly with
the slot. (“E”)
6. Using both hands, push down firmly and evenly on both sides of the DIMM until it
snaps into place and the levers close. (“C” and “D”)
IMPORTANT: Visually check that each latch is fully closed and correctly engaged
with notch on the DIMM edge. (“E”)
7. Replace the air duct and chassis cover if you have completed all work inside of the
server.
3.4.4
Removing Memory DIMMs
Reduce the risk of electrostatic discharge (ESD) damage to the DIMMs and server
board by doing the following:
• Touch the metal chassis before touching the DIMM or server board.
Figure 24.
Installing Memory DIMMs
TS00027
8
E
A
C
D
B
DIMM A1
DIMM A2
DIMM B1
DIMM B2
DIMM D2
DIMM D1
DIMM C2
DIMM C1
Branch 0
Branch 1
