Kontron NSC2U, Product Manual

Page: 55 / 152

Kontron IP Network Server NSC2U
December 2009 Product Guide, rev. 1.4
55
Optional Component Installations—NSC2U Server
4.2.5 Replacing the Riser Card Assembly on the Server Board
1. Attach the riser card assembly to the server board by grasping the two blue
handles and inserting the two riser card edge connectors into the superslot header
and the smaller low-profile riser card header next to it on the server board. (See
“A” in Figure 34 .)
2. Align the forks on the riser card assembly with the pins on the rear chassis panel.
(See “B” in Figure 34 )
3. If this is the last task you are performing, replace the processor air duct and the
top cover of the chassis. Reconnect all the external devices and plug in the power
cord(s).
For information about mounting the server in a rack, see Section 3.5, “Installing
the Server into a Rack” on page 48
4.3 Installing an I/O Expansion Module
There are two types of optional I/O expansion modules available for the IP Network
Server NSC2U:
• A dual GbE NIC module
• An external SAS hard disk drive module
Before installing an I/O expansion module you must remove the top cover, the
processor air duct, and the PCI riser card assembly.
1. Remove the chassis top cover and the processor air duct. For instructions, see
Section 3.2.1 and Section 3.2.5
2. Remove the PCI riser card assembly to access the I/O expansion module site on the
T5000PAL server board. For instructions, see Section 4.2.2, “Removing the PCI
Riser Card Assembly” on page 53 .
3. Squeeze the sides of the I/O expansion module filler panel to remove it from the
rear panel of the chassis. ( Figure 37 , “A”)
Figure 36. Adding a PCI-X/PCIe Card into the Riser Card Assembly
Full-height Add-i n Cards
A
C
D
TS000238
E
B
F