KISS 4U V3 SKX – Preliminary Rev. 0.6
www.kontron.com
// 54
10.2.
Replacing the Fan Assembly
Before replacing the fan assembly, read the following instructions:
Operate the KISS 4U V3 SKX only with a functional fan assembly!
Replace a defective fan assemble only with Kontron’s original fan assembly. see Table 2:
Accessories and Spares Parts.
Fan assembly replaceable during operation.
Replace fan only by qualified specialist or a suitably instructed persons aware of the
associated dangers. Before removing the fan assembly, wait until the fans have totally
stopped. Keep hands and fingers away from rotating fan parts. No tools required! (Key is
required if the front access panel has been locked)
The filter pad holder can be fasten to the front side of the fan assembly either before or
after the fan assembly is installed in the chassis.
To replace the fan assembly, proceed as follows:
1.
Open the front access panel.
2.
Loosen the two knurled screws of the fan assembly (Figure 41, pos. 1)
3.
Pull out the fan assembly on the top side to disconnect the fan assembly from the internal fan control socket
(Figure 42, pos. 3).
4.
Lift upwards and outwards to remove the fan assembly from the fan compartment.
Figure 41: Removing the Fan Assembly
Figure 42: Fan Compartment (without Fan Assembly)
1
Fan assembly with two knurled screws
2
Threaded holes to secure the fan assembly
3
Socket for fan power supply and control
4
Fan compartment
1
3
2
4
