KISS 4U V3 SKX – Preliminary Rev. 0.6
www.kontron.com
// 50
9/
Starting Up
Before staring up, observe the instructions in Chapter 1: General Safety Instruction for IT Equipment.
Recommended intended used is closed and locked
Only when the cover is properly secured with the knurled screws on the rear side and front
side, and the front access panel is locked, is it ensured that the operator does not have
access to the internal parts, loaded with hazardous energy.
9.1.
Connecting the Power Connection
The AC mains input socket is located on the rear side of the KISS 4U V3 SKX.
Power cable and power connectors must always remain easily accessible.
Switching off the power using the front panel power button or the PSU’s power On/Off
switch may not disconnect the KISS 4U V3 SKX platform from the main power source. A
standby-voltage of 5 VSB may remain. The KISS 4V V3 SKX is only completely disconnected
from the main power source, when the power cable is disconnected, either from the mains
power plug socket, or the PSU’s AC power cable connector Therefore, for safety reasons the
power cable must always remain easily accessible.
Ensure that the mains power supply socket (power outlet) is properly grounded and the
power cable is in perfect condition with no visible damage.
The rated mains voltage range must agree with the voltage specified on the type label.
Use a power cable rated for the mains power supply in your country.
Do not disconnect the power from the system while the system is switched on!
Performing a forced shut down can lead to loss of data or other undesirable effects!
To connect the power cable, proceed as follows:
1.
Connect the AC power cord to the AC input power connector.
2.
Connect the other end of the AC power cord to a corresponding mains power supply
3.
Unlock the front access panel (Figure 8, pos. 5) and press the power button (Figure 11, pos. 15).
4.
Close and lock the front access panel.
5.
The power LED illuminates green. (Figure 14, PWR)
