Konica Minolta CM-2600d, Instruction Manual

Page: 34 / 127

E-32
Initial Setting
Setting the LCD Contrast
[Setting Procedure]
<MENU> screen
1
Turn
B
to select “LCD CONTRAST”, then press
A
.
2
Turn
B
to adjust the LCD contrast, then press
A
.
The contrast you set will be con-
firmed, and the <MENU> screen
will reappear.
• Turning
B
to the right will move the contrast adjuster bar to the right, increasing the contrast.
Turning
B
to the left will move the contrast adjuster bar to the left, decreasing the contrast.
• Keeping
B
held down to left or right will cause the contrast adjuster bar to move continuously.
N
ote
On the LCD of this instrument, the display looks darker in a high temperature environment, and looks
paler in a low temperature environment. When this occurs, adjust the display level so that the display
shows its contents properly.
If the contrast is too high or too low, the contents displayed on the LCD cannot be viewed properly. In this
case, turn the power OFF, and then turn it ON again while pressing
A
. The default contrast will be
stored and the screen shown in “Setting the Language and Measurement Mode” (page E-27) will appear.
Adjust the LCD contrast again as explained in “Initial Setting” (from page E-29) if necessary.