Konica Minolta AccurioPress C2060, Quick Manual

Page: 94 / 184

6.1 Both Sides Adjustment 6
AccurioPress C2070series 6-20
14
Press [Exit Print Mode].
15
Measure a misalignment between the
marks of [1] to [4] printed on the [back]
side of the output chart and the marks on
the [front] side.
%
The figure shows an example to measure [1].
The scale resolution is 0.5 mm.
%
In this figure, the black mark indicates
the front side and the blue mark indi-
cates the back side.
%
Measure a misalignment between printing
positions in the horizontal direction (X axis)
and vertical direction (Y axis).
% The measurement value can be entered in
units of up to 0.1 mm.
% For example, as shown in the figure, if
at point [1] is misaligned 2.0 mm in the plus
side of the X direction and 1.5 mm in the minus side of the Y direction compared with the front side,
press [2] - [0] - [+/-] in the X direction to enter "-2.0" as the adjustment value, and press [1] - [5] in
the Y direction to enter "+1.5" as the adjustment value. Then, at point [1], the blue line on the back
side will be moved 2.0 mm toward the minus side of the X direction and 1.5 mm toward the plus
side of the Y direction.
% Write down the measured values so that you do not forget them.
>@
[
\
back