Komatsu Galeo HD405-7R, Operation & Maintenance Manual

Page: 302 / 361

.
ATTACHMENTS, OPTIONS
HANDLING PAYLOAD METER II (CARD TYPE)
NOTICE
When stopping the machine empty, stopping it during loading, or stopping it when loaded, always set to the gearshift lever at the
N position. (See "DISPLAY DURING NORMAL OPERATIONS (PAGE 6-21)".)
If this is not done, the time that the machine is stopped will not be calculated, and it will be included in the travel time when empty
or the travel time when loaded. As a result, the average travel speed will appear to be lower and the data stored in the payload
meter will not be accurate. In addition, the external display lamps will also stay OFF.
NOTICE
In the following cases (1) to (4), the condition of the dump truck as seen by the payload meter will be different from the actual
condition of the dump truck.
(1) When a new controller has been installed
(2) When the controller has been replaced
See "OPERATION WHEN ERROR CODE F.CAL IS DISPLAYED OR CONTROLLER HAS BEEN REPLACED
(PAGE 6-63).
(3) When the built-in battery has been replaced
See "WHEN ERROR CODE F-09 IS DISPLAYED (PROCEDURE FOR REPLACING BATTERY) (PAGE 6-60).
(4) In addition, if either of the following conditions should occur
The external display lamps give the estimate display although no loading is taking place.
The display gives the time display when loading even if more than 50% of the standard payload is loaded and
the machine starts to travel. (The distance display is not given when traveling 0 to 160 m.)
In the case of (1) or (4), carry out calibration with the machine empty, then load it close to the rated payload and
dump the load. The payload meter will recognize the empty (stopped) condition.
Note that the cycle data recorded when dumping may be partially inaccurate.
NOTICE
After starting dumping (operating the dump lever from FLOAT to RAISE), do not turn the power OFF within 5 seconds after
completing the dumping (operating the dump lever from LOWER to FLOAT).
Also, with operations other than dumping, do not turn the power OFF within 5 seconds after operating the dump lever to FLOAT
from any position other than FLOAT.
If the starting switch has been left at the ON position (power ON) for a long period without starting the engine, first turn the
starting switch to the OFF position, then start the engine.
If the engine is started without turning the starting switch first to the OFF position, the time that the starting switch was at the
ON position without starting the engine will also be calculated as part of the "Stopped, Empty" time or the "Stopped, Loaded"
time.
6 - 23