(Semi-U dozer, U-dozer)
Lower blade (a) so that the tilt cylinder length is the value
in the table below.
Lower ripper (b) to the ground with the pin at the bottom
so that the length of each cylinder is the value in the table
below.
<Reference>
Item
Dimension
Blade
(DUAL)
Tilt cylinder length
1374 mm
Blade
(SINGLE)
Tilt cylinder length
1374 mm
Brace
1374 mm
Ripper
(VGR, VMR)
Lift cylinder length
1477 mm
Tilt cylinder length
1431 mm
3.
Approximately 5 minutes later, check the oil level with sight
gauge (G).
If the oil level is between H and L of sight gauge (G), it is
proper.
NOTICE
Do not add oil above H line. It may damage the oil cir-
cuit and cause the oil to spurt out.
If the oil level is higher than H line, stop the engine,
wait until the hydraulic oil cools down, and then re-
move drain plug (P), loosen drain valve (1), and drain
excessive oil.
MACHINE OPERATIONS AND CONTROLS
OPERATION
3-144
Summary of Contents for D155AX-8E0
